Amerex Fill Cap Gasket - 08392
Are you a fire protection company? Get wholesale pricing
Wholesale PricingThe Amerex 08392-P001 Fill Cap Gasket is the OEM pressure seal for the fill port cap on Amerex fire extinguisher cylinders. During a fire extinguisher recharge, the fill cap is removed to introduce the dry chemical agent into the cylinder. The fill cap gasket is the compression seal that maintains a gas-tight interface between the fill cap and the cylinder neck once the cap is reinstalled and the unit is pressurized.
This gasket is a mandatory replacement item at every fire extinguisher recharge and 5-year internal examination. Reusing the old fill cap gasket after depressurization is a major NFPA 10 compliance violation — the elastomer undergoes permanent compression set during service and will not reseal reliably when reused. A leaking fill cap is a slow-bleed deficiency that can leave a unit partially depressurized between inspections without triggering the pressure gauge alarm zone.
As an essential fire extinguisher service part, the 08392 belongs on every fire extinguisher recharge kit and service vehicle inventory. It is compatible with the standard Amerex fill cap assembly across a broad range of ABC dry chemical, Purple-K, and specialty agent cylinders. Keeping a supply of these on hand ensures zero-delay service during high-volume fire extinguisher refilling operations.
| Feature | Details |
|---|---|
| Manufacturer | Amerex Corporation |
| Part Number | 08392-P001 |
| Component Type | Fill Cap Gasket / Pressure Seal |
| Material | Pressure-rated elastomer |
| Application | Amerex cylinder fill port cap |
| Service Interval | Replace at every recharge and 5-year exam |
| Certifications | UL Listed, OEM Original |
Mandatory Replacement Rule
The 08392 fill cap gasket must be replaced every time the fill cap is removed during fire extinguisher service — including recharges, internal examinations, and hydrostatic testing. This is not optional. NFPA 10 standards require all seals in the pressure path to be replaced during any service that involves depressurization. Document the gasket replacement on the fire extinguisher inspection record tag.
Installation Protocol
Before installing the new gasket, inspect the fill cap seat and the cylinder neck threads for corrosion or debris. Clean thoroughly before seating the new 08392. Apply a minimal amount of silicone-compatible lubricant to the gasket to ease installation and prevent tearing during cap torque-down. Over-lubrication can introduce contamination into the agent charge — use sparingly.
Signs of Gasket Failure
A slow leak at the fill cap will present as a gradual pressure drop on the fire extinguisher pressure gauge between inspection cycles. During fire extinguisher service, check the fill cap area with a soap solution after pressurization. Any bubbling indicates the 08392 has failed and must be replaced before the unit is returned to service.
Can I reuse the old fill cap gasket if it looks undamaged?
No. Even if the gasket appears visually intact, the elastomer undergoes irreversible compression set during service. Reusing the old gasket violates NFPA 10 and creates a high probability of slow-bleed leakage. Always install a new 08392 from your fire extinguisher service parts inventory during every recharge or internal exam.
Is this gasket compatible with all Amerex models?
The 08392 is compatible with standard Amerex fill cap assemblies across the ABC dry chemical, Purple-K, and select specialty agent lines. Always verify against the Amerex fire extinguisher parts list for your specific model before service to confirm the correct gasket specification.
