BFR-10R Buckeye Recharge Chemical

The Buckeye BFR-10R Recharge Chemical serves as the mid-range hydraulic solution for the Kitchen Mister fire suppression system, specifically pre-measured for the Model BFR-10 cylinder. While smaller units are ideal for targeted protection, the BFR-10R is engineered for the heart of the house in mid-sized commercial environments. This 10-flow standard agent provides the necessary capacity to manage multiple high-velocity hazards, including two or three large deep-fat fryers and a full plenum section, without the footprint of a dual-tank industrial system.

Formulated as a high-alkaline, potassium carbonate-based solution, the BFR-10R achieves a precise atomization pattern when propelled by 195 PSI of nitrogen. This is critical for the chemical transformation where the agent reacts with hot lipids to create a thick, fire-extinguishing soap foam. For operators managing casual dining chains or secondary school cafeterias, the BFR-10R represents the ideal balance between fire-fighting capacity and hardware efficiency, ensuring that a standard 10-to-12-foot hood remains fully compliant with UL 300 and NFPA 17A mandates.

The BFR-10R must be installed exclusively in the Buckeye Kitchen Mister BFR-10 cylinder by a certified fire suppression technician in accordance with NFPA 17A and the Buckeye system design manual. Before refilling, the technician must perform a full internal inspection of the cylinder to verify it is free of corrosion, sediment, or residual agent. The BFR-10R is pre-measured as a single-volume refill for the BFR-10 tank and must not be split between multiple smaller cylinders, as inaccurate volume distribution can cause hydraulic failure during discharge.

Following the fill, the cylinder must be pressurized to the factory-specified operating pressure of 195 PSI and undergo a calibrated leak test before being returned to service. To maintain UL 300 compliance, NFPA 17A requires a full internal inspection and agent replacement every 6 years. Using the genuine BFR-10R refill ensures the solution has not undergone chemical shifts, maintaining the facility's factory-rated ready state. In the event of a discharge, the potassium carbonate residue should be cleaned promptly with warm water, and staff should wear gloves during cleanup to avoid skin irritation from the high-alkalinity solution.

Can a BFR-10R recharge be split between two BFR-5 cylinders?

No. While the total flow points equal 10, the BFR-10R is pre-measured as a single-volume refill for the BFR-10 tank. Attempting to split the agent leads to inaccurate volume distribution and potential hydraulic failure. To maintain the UL 300 listing, always use the specific recharge model that corresponds to your cylinder's part number.

Why is the 10-flow point system preferred for franchise standardization?

The BFR-10R is the sweet spot for the standard hoods found in most franchise restaurants. By standardizing on the 10-flow point tank, multi-unit operators can simplify their maintenance inventory, ensuring service contractors are always prepared with a single, high-capacity recharge SKU that covers the majority of their kitchen layouts.

Does the BFR-10R require different nozzles than the BFR-5R?

The chemistry is identical, but the BFR-10R allows for up to 10 total flow points. Because the BFR-10 cylinder has a larger internal volume, it maintains the necessary pressure-to-agent ratio to push the chemical through the longer pipe runs common in institutional dining facilities.